Please be sure that the router is off while inserting the card to the slot. Insert the serial card ( here we are taking HWIT-2T )to the appropriate serial card slot. The serial interface is not integrated with the router, hence it has to be fitted externally.Use Serial Cable to connect the serial interface of the two routers for point to point connection.Use RJ 45 copper straight cable for connecting router LAN interface ( Gigabit Ethernet Port) with Switch Fast Ethernet port and switch to PC as shown in the diagram.Connect them using the appropriate cables.Take two Cisco Routers Model 2911, two Ethernet Switches, and four generic PCs.Here, we are taking two routers for static routing configuration. The CLI command for configuring static routing is: Router(config)#ip route
We have to make the entry of indirectly connected networks via next-hop router interface IP or the exit interface. While configuring the static routing, we do not have to make the entry of directly connected networks, since they are locally connected with the router ports. As the network size increases, it is difficult to manage every router manually. But, static routing is more effective in smaller networks. It is considered to be more reliable and secure routing than dynamic routing. Static routing between two routers is configured manually by the network administrator. Hence, it is much better and economic for the hands-on practice of the Cisco router Commands.
Simulation software works well and accepts almost all the CLI commands. However, It will be better if you can afford two live routers, but economically it is not feasible.
#Configure router for wol install#
You can download them and install them on your system. This software is freely available on their respective official sites. You can also use other Simulation software like Boson, GNS, etc.
#Configure router for wol how to#
In this section, we will be going to discuss how to configure Static Routing between two routers using Cisco Packet Tracer.